Sterling 360, Driver'S And Maintenance Manual

Page: 193 / 213

12-19
8. Open the door, then tighten the keeper screws
behind the front and side turn signal lens
and the keeper screw behind the reflector .
CAUTION
•
Press the front and side turn signal lens fully
in toward the centerline of the vehicle. If the
lens was not pressed fully into place and you
opened the door, the door could hit the lens
and damage it.
•
Do not tighten the keeper screws too much.
This could damage the mounting.
9. Fit the headlight bezel under the headlight
onto the tabs by moving it toward the outside
of the vehicle.
10. Fit the rivet , then press in the screw .
1.2 Headlight bulb replacement
•
Removal
1. Remove the rear cover . Press it in and turn it
counterclockwise (in the direction of arrow ).
2. Pull the connector toward you to remove it.
3. Move the wire retainer away from the bulb .
4. Remove the bulb.
•
Installation
1. Align the tabs on the bulb collar with the
grooves , fit the bulb in place, and fasten the
wire retainer.
2. If the packing is dirty, clean it. If the packing is
kinked, install it properly.
3. Securely press the connector into place.
4. Install the rear cover. Press it in and turn it clock-
wise (in the direction of arrow ).
1.3 Parking light bulb replacement
1. Turn the bulb fixture counterclockwise (in the
direction of arrow ) to remove it.
2. Remove the bulb from the fixture.
3. To install the bulb, turn the fixture clockwise to
tighten it.
4. If the packing is dirty, clean it.
Z11624
Z11275
Z09155
Z11276