2-3
Uncrating Instructions
Uncrating/Installation Instructions
122990-608
1.
Remove all tape from dryer.
2.
Check that filter is correctly installed in top access panel. Filter
should rest in panel cutout, under tabs (see Figure 2-3).
3.
Check that filter clip is positioned directly over filter. If neces-
sary, loosen wing nut, move filter clip over filter and tighten wing
nut.
4.
Attach top access panel to unit with screws previously re-
moved.
5.
Open chamber door(s). Remove and unwrap shelves, guide
tabs and Operator Manual.
6.
Make sure operator receives Operator Manual.
7.
Insert guide tabs into shelf support strips in chamber (see
Figure 2-4).
8.
Place shelves on guide tabs.
9.
Close chamber door(s).
10. Remove all packing and tape from control panel.
11. Discard all packing material removed during uncrating proce-
dures.
Prepare Dryer for
Installation
12345678901234567890123456789012123456
12345678901234567890123456789012123456
12345678901234567890123456789012123456
12345678901234567890123456789012123456
12345678901234567890123456789012123456
Figure 2-3. Check Filter Installation
Panel Cutout
Tabs
Filter
Filter Clip
Wing nut
