12
3.2 Electrolysis cell
Dimensions:
Length 275 Height 180 mm Depth 152 mm.
Each cell has two PVC end fittings with
inside diameter of 50 and outside diameter of
63. These end fittings must be affixed to the
by-pass on the filtration circuit using PVC glue.
Assemble the electrolysis cell in by-pass as
shown in the diagrams above with three
valves, on the backflow circuit (return to the
swimming pool), after the filter, after any
analysis
electrode
and
any
booster
compressor or heating outgoing cable.
However, the cell can be assembled without
by-pass on installations with a pump with
power below 1 hp.
Warning, the bypass valves must be open to
allow the water to pass through the
electrolysis cell before STERILOR Sel is started
up.
The electrolysis cell must be under a
flow of
water
when STERILOR Sel is operating.
The cell should preferably be installed
horizontally, at 45° towards the top. This
orientation ensures the evacuation of water
that may appear on the cap (condensation,
splashing, etc.)
Effectively, the electrode connectors must not
be in contact with water. Non-compliance
with this guideline may result in premature
corrosion of the connectors and premature
deterioration of the cell.
Titanium electrodes coated with precious
metal oxides:
Place the electrode with its seal in the
electrolysis cell.
Rotate it on its support to wedge it correctly
so that the water circulates between the
electrode's plates as indicated on the diagram
below.
The water must flow between the electrode's
plates. The flow of pool water must arrive on
the section of the plates and not opposite the
plates.
Electrode connections Connect the cable
provided for this purpose to the box, quick
connectors.
3.3 Cover Connection or Servocontrol
Connection:
Quickly connect the connector to the
left-hand lateral connector provided for this
purpose, see point 2.1.4. (
Important: this
contact must absolutely be a dry contact - not
connected to the power supply
)
Orientation
of the cell
45° from the
vertical
Summary of Contents for Sel
Page 2: ...2 ...