5
8. Once it is determined that there
are no leaks, plug the system into
the ground fault interrupter, and
check controller to ensure the
system is operating properly.
The controller is designed to
detect both power to the system
and lamp illumination. It is
important to NEVER LOOk
DIRECTLY AT THE GLOWING UV
LAMP.
9. Allow the water to run for a few
minutes to clear any air or dust
that may be in the reactor.
pLEAsE NOTE:
When there is no flow,
the water in the cell will become
warm, as the UV lamp is always on.
To remedy this, run a cold water tap
anywhere in the house for a minute
to flush out the warm water.
Alternatively, install a temperature management valve (PN 440179).
