Steinway & Sons P300 2.1 Owner’s manual
8
Home Automation System Integration
The Model P300 2.1 is compatible with home automation systems via the RS232 and network
connector on the rear socket panel. The Model P300 2.1’s IR and trigger connections can also be
programmed for use in a home automation system.
IP Control
Open a TCP connection on port 84 and use the same protocol as on the serial interface (see Model
P300 2.1 Serial Control Manual). Use Telnet, Putty, or similar programs to open the TCP connection.
If you do not know the IP address of the Model P300 2.1 on your local network, the Model P300 2.1
supports Apple’s Bonjour Discovery service, which must be on the computer you want to set up the
Model P300 2.1 with. The software is built-in as part of the Apple OS X operating system (not iOS
devices). For Windows operating systems, the software can be found at
http://www.apple.com/support/bonjour/
Pressing the OK button on the remote and toggling through Info will also display the current IP
address of the unit.
Access the Model P300 2.1 by going to http://P300.local in your browser.
Preparing for Mounting in a Rack
The Model P300 2.1 processor is equipped from the factory with feet for free-standing placement on
a shelf, table, or rack.
To install the Model P300 2.1 in a rack:
Turn the Model P300 2.1 upside down and place it on a stable, even surface.
The screws used to fasten the rack brackets to the bottom of the Model P300 2.1 are in the holes
designated for the brackets when the product leaves the factory.
Fasten the brackets for rack mounting to the Model P300 2.1.
Mount the Model P300 2.1 in a rack.
