Steinway & Sons P300 2.1 Owner’s manual
11
How to Pair Remote
The remote control is paired to the Model P300 2.1 at the factory, and you only need to pair it again if
you have a new Model P300 2.1 or remote. To pair the RF remote control to a Model P300 2.1:
Turn on the Model P300 2.1.
Hold down the Play & OK buttons until the remote control’s green LED flashes.
Point the remote control at the Model P300 2.1 and hold it within 30cm / 1 foot of the front panel;
when the green LED stops blinking, the remote is connected via Zigbee.
The remote will be paired to the Model P300 2.1.
To reset the pairing of the remote control, press Back and OK until the red LED flashes twice.
Switching the Remote to RF or IR Mode
To switch the remote from RF to IR mode, hold down the OK and 1 buttons. The LED will flash red
twice.
To switch the remote from IR to RF mode, hold down the OK and 2 buttons. The LED will flash green
twice.
