Steinway & Sons P300 2.1 Owner’s manual
24
System Configuration
General Setup
Power management
Choose the standby mode:
Deep sleep: The Model P300 2.1 cannot be turned on via LAN or a control system.
Network: The Model P300 2.1 can be turned on via LAN or a control system.
The Model P300 2.1 cannot turn on from standby via LAN B; please use LAN A instead.
Choose the delay before auto off (minutes). If you don’t press any buttons or audio isn’t being
played, this sets the idle time required for automatic shut-down.
Default volume settings
Set a max volume for the device (dB). This setting is a safety precaution.
Set startup volume.
Use last volume: Sets the volume to be the same as when Model P300 2.1 was turned off.
Use fixed volume: Sets the default volume at startup.
HDMI CEC settings
Set enable CEC and use ARC channel as audio input to Off or On.
Display timeout
Set seconds before turning off the display.
Password protection
Set a required password to enter the web setup section.
Control of speaker setups
Set to allow sources to change speaker setup to No or Yes.
Show bypass
Set the bypass mode for your device to Off or On.
Enable front IR sensor
Turn the Model P300 2.1’s IR sensor Off or On. This function is useful if you are using a home
automation system and other remotes are using the same IR codes as the Model P300 2.1 remote.
