STEINEL S-Former E, Assembly Instructions Manual, Page: 71 / 92

Version 12.2022 Assembly instructions 71
12 Technical data
Gear
Ratio 4.615:1
Pneumatic system
Pressure (bar) 2…4, depending on application max. 6
When using the STEINEL S-Former E control unit, the limits are automatically detected and set.
When using another control unit, the following limits must be set:
Limits
Motor side Output side
Rotation speed [1/min] 5 500 1 191
Peak torque (Nm) 8.667 40
Peak current (A) 9.319 –
The STEINEL S-Former E control unit fulfils all the requirements pertaining to the servo controller’s output
and current.
When using another control unit, ensure that the servo controller in use is able to fulfil the continuous
and peak outputs and currents.
The expected lifetime is dependent on the application, load, ambient conditions,
general handling and maintenance.
The following lifetime specifications are empirical values. They serve for orien-
tation and information and are not obligatory.
Lifetime under optimal usage conditions
AC Servodrive 20 000 h/ 5 years
Ball bearings 20 000 h
Toothed belt stage 1 10 million cycles
Toothed belt stage 2 10 million cycles
Spline shaft 10 million cycles
Splined hub 5 million cycles
Cylinder 5 million cycles
Valve 5 million cycles