STEINEL S-Former E, Assembly Instructions Manual, Page: 38 / 92

38 Assembly instructions Version 12.2022
9 Tool change
1
Spindle
2
High-speed
clamping insert
3
Clamping nut
4
High-speed
clamping insert,
shaft diameter
5
High-speed
clamping insert,
square end
4. Remove the high-speed clamping insert
2
from the spindle
1
.
5. Insert the new high-speed clamping insert
2
into the spindle
1
so that the carrier wings of the
insert become seated in the spindle openings.
6. Retighten the clamping nut
3
.
7. Select a high-speed clamping insert
2
whose shaft diameter (red)
4
, square end (yellow)
5
and
total length (grey) are a suitable fit for the tool to be used.
8. When inserting the tool, ensure that the square end of the tool locks into the inner square (yellow)
of the insert by slightly twisting it.
9.5 S-Former E1.2
9.5.1 Changing the tool
1
Spindle
2
Hook wrench
3
Tool
4
Clamping nut
5
Open-end spanner
SW22
1. Pull out the spindle
1
by hand.
2. Loosen the clamping nut by approx. 1 revolution
4
using the hook wrench
2
and fix the spindle
1
using an SW22 open-end spanner
5
.
3. Pull the tool
3
out of the collet by hand.
4. Insert the new tool into the collet by hand.
5. Slightly twist the tool until its square end locks into that of the reducer (not visible here) or spindle.
6. Retighten the clamping nut
4
.
4
5
1 2 3
1
2
3
4
5