BM-7
BM-7
Operator’s Manual
9
3. STARTUP AND OPERATION
3.1. Installing and removing the cutting inserts
Unplug the power cord. Loosen the screw
(
1
) and then turn the sleeve (
2
) to lower it
as far as possible and get access to the milling head. Use the special wrench (
3
) to
loosen the roller, and then use the screwdriver (
4
) to remove the cutting inserts. Clean
the sockets.
To change the cutting edge, turn the inserts by 90°, push them to the sockets, and
tighten the inserts and the roller. If all cutting edges are worn, install new inserts. Make
sure that the bottom of each insert is in full contact with the socket (
5
).
Each week clean the threads of the mounting screws for inserts and put the
supplied grease on the threads.
2
1
CORRECT
INCORRECT
5
3
4
