BM-7
BM-7
Operator’s Manual
13
3.5. Operating
Install the required milling head with cutting inserts, and set the required bevel width.
Connect the machine to the power source and put the machine on the left as in the
figure. Make sure that the workpiece is stable.
To start the motor, press and hold the switch lock (
1
) and the ON/OFF switch (
2
),
and then release the lock (
1
). Next, wait some seconds until the speed is at the
maximum. Press
the
machine
to
the
workpiece with the two hands. Then, slowly slide
the machine toward the edge until the tool starts cutting. Move the machine from left
to right (
4
).
Bevel in two passes. Set the bevel width to a value that will allow the feed of
1 m/min without using too much force.
If there is vibration in the machine or if the cutting inserts are dull or damaged,
turn off the machine. Then, turn the cutting inserts by 90° to change the cutting edges.
If all cutting edges are worn, install new inserts.
Replace inserts before they become dull to prevent the overloading.
Also, take
periodic breaks during work. This prevents overheating and damage to the windings.
After the work is finished, release the ON/OFF switch to turn off the motor. Then,
wait until the rotation stops, and unplug the power cord.
Clean
the
machine
with a dry cotton cloth and no chemical agents.
4
1
3
2
