Desk Cabinet Assembly
1.
Place unit on a clean surface with front facing
down.
2.
Remove both shipping brackets from the bottom
of the cabinet.
3.
(Requires two people) Align and place unit on
top of Base Frame.
4.
From under the Base Frame, install clamp
brackets with fasteners, making sure each
bracket is fully engaged with the frame and
tighten securely. For best results, fasteners
should be tightened to 180 in/lbs. or 15 ft/lbs.
5.
Install worksurface by inserting three tabs
into corresponding slots in the front of the back
panel of the cabinet (5a). To secure worksurface
from behind the cabinet, install all wedge blocks
into the slots from the bottom, gently tapping them
up until tight (5b). Lock all wedges in place with
#10 wood screws (5c).
6.
If a task light is to be installed in the cabinet,
refer to page 9 before advancing to allow ease of
access to power cords. Install back panel (if
applicable) by inserting top brackets into slots
in the cabinet top panel, then pushing bottom
into place. Secure with 1/4-20 screws
through clearance holes in the base.
3
4
4
1
2
5a
BASE
REAR OF
CABINET
TABLE
5b
TABLE TAB
6
BACK PANEL
5c
CLAMP BRACKET
(ENLARGED)
®
HEALTH
Page 8 of 13
Doc # 135357
939599300 Rev C
