Base Frame Extension Assembly for
Cabinets (11”D)
1.
Remove packaged aluminum trim and set aside. Trim will
be assembled later.
2.
Place the Extension Frame and Link on a clean surface
adjacent to the mating Base Frame.
3.
Two legs will be transferred from the mating Base
Frame to the Extension Frame. Remove attachment bolt
from top of legs.
4.
Insert two (2) legs into clevis brackets at the corners of
the 55” wide side of the Extension Frame. NOTE: The square
notch in the clevis brackets will determine the orientation of
the legs (refer to illustration).
5.
Install clevis attachment bolts from step 3 and tighten
securely with 1/4” hex wrench (”Allen Key”). For best results,
bolts should be tightened to 180 in/lbs. or 15 ft/lbs.
6.
Install Link by aligning holes at the corners of the Base
and Extension Frames and installing four (4) clevis link
pins. Note: link pins do not require cotter pins.
1
2
EXTENSION
TRIM
6
LINK
BASE
LINK
EXTENSION
LEG HERE
IN STEP 4
LEG HERE
IN STEP 4
3
4
5
LEG
SQUARE
NOTCH
EXAMPLE OF HOW
CABINETS MIGHT BE
MOUNTED ON EXTENSION
FRAMES ON BOTH ENDS OF
A BASE FRAME.
1
®
HEALTH
Page 2 of 13
Doc # 135357
939599300 Rev C
