Page 13
WARNING
!
BASIC FEEDER AND SUPPORT
ASSEMBLY MOVEMENTS
Make certain that both machines are disconnected
from the power source.
1. To rotate the feeder assembly, loosen locking lever
(A)
on the base and swing the assembly into the
desired position .
Fig. 13
2. To raise or lower the feeder, loosen the locking lever
(D)
and turn the handle
(E)
.
3. To move the feeder in or out, loosen locking lever
(B)
and rotate the handwheel
(C)
.
4. To adjust the position of the feeder in relation to the
fence, loosen locking lever
(F)
and rotate the feeder
body.
5. To adjust angle of the feeder in relation to the table,
loosen the pull handle
(G)
. Pull-out the
Memo-Positioning pin
(H)
, grab the Flip Handle
( 1, Fig. 10)
and rotate the feeder body.
6.
Tighten all locking levers after adjustments
are complete.
Fig. 13
SIDE FEEDING
1. To rotate the feeder assembly, loosen locking lever
and swing feeder off the table.
2. Release the Pull handle
(1)
, grab the Flip Handle, pull
up the Memo-Positioning pin
(2) Fig 14
and turn the
feeder according to vertical position.
Swing feeder back to table, tighten all levers.
Fig. 14
3. For the 4 rollers feeder: proceed step 1. Then loosen
lever
(F)
, turn Control-Joint 90° clockwise
( Fig. 15 )
and proceed step 2.
Fig. 15
INCLINED FEEDING
1. Loosen the lever and swing the feeder off the table.
2. Loosen screws on the over-arm cone
(K)
, turn the
Control-Joint along the feeder body and set the
desired angle
(S)
, then tighten the screws
(K)
.
Fig. 16
3. Loosen levers
F
and
G
, grab the Flip Handle, pull
up the Memo-Positioning pin, turn the feeder back to
horizontal position, swing feeder back in operating
position, make sure all rollers are aligned with the
workpiece and then tighten all levers.
Fig. 17
4. Workpiece should lean against the fence closely when
feeding. Rollers should have a pressing angle to the
fence during infeed. The gap between infeed rollers
should be 3-4 mm larger than outfeed rollers.
Fig. 18.
5. During side feeding, the gap between infeed rollers
should be 3-4 mm larger than outfeed rollers.
6. The Memo-Positioning pin has default pressing angle
setting. After initial gap adjustment, when switching
to side feeding, gap readjustment is not necessary.
Fig. 16 Fig. 17
Fig. 18
ADJUSTMENTS
