Page 11
WARNING
!
The stock feeder and auxiliary machine to which you are
mounting the stock feeder should be disconnected from
the power source during installation.
NOTE
: Keep in mind the length of the horizontal arm
when mounting the stock feeder so you have room for
proper adjustment.
NOTE
: Leave enough space around the work area for
loading and off-loading stock.
IMPORTANT
: Make sure the base machine is secured
to the floor or has sufficient supporting weight that will
prevent both units from toppling over when feeder is
swung over the edge of the base unit.
Fig. 1
Fig. 1
Make certain that both machines are disconnected
from the power source.
1. Position the base by the rear-side of the outfeed with
the feeder towards the infeed direction.
Fig. 2
ATTACHING THE
TABLE MOUNTING BRACKET
Fig. 2
WARNING
!
2. Clean the mounting surface and apply the supplied
self-adhesive drilling template.
Fig. 3
3. Match the template to your base, mark the holes with
a center punch and remove the template.
4. Drill and tap for M12 bolts (not provided).
NOTE: DO NOT drill through any table ribs or
table supports.
5. Secure the mounting bracket to the table with four
M12 bolts and lock washers. If surface is not thick
enough for proper tapping, use appropriate length
bolts and fasten using flat washers and hex lock nuts
(not provided).
Fig. 3
ATTACHING THE SUPPORT
ASSEMBLY
1. Loosen locking lever
(A)
and insert stand in base.
Fig. 4
2. Assemble handle.
Fig. 4
Fig. 5
A
ASSEMBLY
