20
CIRCLE CUTTING ATTACHMENT
1.
2.
3.
4.
5.
Layout the parts on the table for easy access.
SEE FIG.26
(refer and match parts from FIG.25) .
Place the slide base
(G)
around the elevation rod
(X)
and position the slide block
(F)
into position to drop into
place.
SEE FIG.27
.
With the slide block in position
(G)
, tighten the Allen screw
(E)
with the hex wrench
(B)
.
SEE FIG.28
.
Slide the rod
(D)
into position through the slide base
(G)
by loosening the knob
(H)
and then tighten knob.
SEE
FIG.29
.
Loosen the thumbscrew
(C)
and slide the drawing pin
(A)
through the rod
(D)
.
SEE FIG.30
.
A.
B.
C.
D.
E.
F.
G.
H.
Drawing Pin
Hex Wrench 5 mm
Thumb Screw
Slide Rod
Allen Screw
Slide Block
Slide Base
Knob
INSTALLING CIRCLE CUTTING ATTACHMENT
To use this attachment, place your stock on the table. With the center marked on the wood, position the drawing pin over
the cross by loosening the knob and the thumbscrew. Tighten the knob and use a mallet to tap the top of the drawing pin
to seat in the X cross on the wood and tighten thumbscrew. Next, turn on the bandsaw and begin to push stock through
the blade to cut. For a live demonstration, check out on YouTube.
A
B
C
D
G
H
E
F
FIG.25
FIG.26
FIG.29
FIG.30
FIG.27
FIG.28
A
H
G
D
B
E
F
G
X
X
G
B
F
F
E
D
G
H
A
C
D
