25
1.
2.
3.
4.
5.
6.
7.
8.
Open the lower door by rotating the black knob counter clockwise
(A)
.
SEE FIG.37
.
Remove the 3 screws on the right side
(B)
and repeat on the left side with a Philipp’s driver (not supplied).
SEE
FIG.37
.
Release blade tension. Refer to instructions for CHANGING THE BLADE. Remove the blade.
With the belt exposed, loosen the wing nut
(B)
and turn knob counter clockwise
(A)
to release the bearings
(D)
from
touching the belt
(E)
.
SEE FIG.37
.
Remove belt from upper pulley
(H)
and lower pulley
(F)
.
FIG.38
.
Remove belt by bringing up through the opening and move over the wheel starting on the left side and under the
wheel and off the right side.
To replace, reverse the process and place either on the same step of the pulley. Refer to CHANGING SPEEDS.
FIG.28 (G)
shows that there are 2 steps on the lower pulley. There are also 2 steps on the upper pulley.
Reattached the lower panel and replace the 6 Philipps screws that were removed. Install the blade and apply proper
tension and tracking. Close the door and lock by clockwise turning the black knob.
REPLACING POLY-V BELT
NOTICE:
Before operating bandsaw, make sure to go back to the ADJUSTMENTS section of this manual and redo the
following sections:
Setting Blade Tension
Blade Tracking
Upper and Lower Guide Bearing Adjustments
MAKE CERTAIN THAT THE SAW IS DISCON-
NECTED FROM THE POWER SOURCE.
WARNING
!
FIG.37
FIG.38
A
B
E
A
H
B
D
G
F
