Steel City 10-722, Owner'S Manual

Page: 9 / 36

Page 9
ASSEMBLY
◊ ATTACHING STAND TO THE MACHINE
1. Assemble the stand first. with 16 carriage bolts, washers
and hex nuts, begin assembling one end of stand by
attaching 1 short shelf and 1 long brace to legs.
2. Assemble the opposite side of the stand the same way
as described in step 1.Then use the 2 short shelves and
2 long braces to join both assembled ends and
complete the stand then place upside down complete
on a level surface and tighten all nuts.
3. Attach the 4 leveling feet to the stand by using 4 hex
nuts and 8 washers, place in its final location after fully
assembling, level the feet by loosening the top nut,
adjusting lower nut up or down on the screw stem as
needed, then tightening down the top nut.
4. Assemble the stand to each corner (see picture) of the
base underneath. Use 12 hex head screws & flat
washers.
WARNING
!
Use a heavy-duty lifting device (fork
lift, pulley, etc.) with lifting straps and
steel rods that can support the weight
to lift the machine to stand.
Remove the 3 insert boards to access the lifting hook
mounting holes and then thread the 2 lifting hooks A.
Make sure the saw carriage is locked next to the
column by tightening the lock lever.
Lock lever