Steel City 10-722, Owner'S Manual

Page: 12 / 36

Page 12
6. Remove the hose, loosen the two cap screws on the
guard and remove it.
8. Install the new blade onto the arbor with the teeth
pointing to the right. Re-install the arbor nut. Immobilise
the blade with hand and tighten the arbour nut. Do not
over tighten ! Each start tightens the nut.
7. Remove the arbor nut by turning it clockwise and by
immobilising the arbor with an Allen key. If a blade
change is necessary, remove it.
Tight
Loose
Remember: tighten the arbor nut by tightening in the
opposite direction of the rotation of the blade.
ALWAYS wear protective glooves when
handling the blades. Teeth are very sharp.
WARNING
!
◊ RIVING KNIFE
1. Remove the two cap screws from tthe back of the
guard.
2. Two positions are possible for two blade diameters:
(10 and 12 or 14 and 16 inch depending on machine
model). Align the oblong hole of the riving knife with the
thread holes of the guard and begin to tighten the cap
screw. Align the riving knife with the blade and tighten
the cap screws in place.