Steel City 10-722, Owner'S Manual

Page: 18 / 36

Page 18
◊ ADJUSTING TABLE TOP PARALLEL
TO TRACK-ARM
For accurate work the track-arm must be parallel to the
table top at all points.
1. Move the motor and carriage assembly to the vertical
position . Position saw arbor, so that it is approximately
in the center of the front table board. Pull track-arm
clamp handle to the rear to secure track-arm and tighten
carriage clamp knob.
◊ LUBRICATION
All ball bearings are sealed type and require no further
lubrication.
◊ OIL THE COLUMN
◊ GREASE NOTCHES
3. Move carriage until the saw arbor is at the left front
table, as shown. Make sure track-arm clamp lever and
carriage lock knob are tightened. Using the block as a
feeler gauge check to see if an adjustment is
necessary.
Hex head
screw
Eccentric screw
2. Using the block as a feeler gauge, raise or lower the
track-arm by turning elevating handle until saw arbor
just touches block. Do not raise or lower trackarm any
further until leveling adjustments are completed.
4. To lower the table, loosen hex head screw and lock nut
on the eccentric screw. Adjust the eccentric screw to
raise or lower the table Check table back at points and
adjust if necessary. Check table on right side in the
same manner.
MAINTENANCE