56
749.082 | Z02 | 2015-02-03
EN
9.3 Restoring the configuration file
For safety purposes, a copy of the configuration file containing the factory default settings is stored
under the name "Config.wri.backup" in the "Config" directory. If problems occur after editing the config-
uration file "Config.wri", delete the file "Config.wri" from the Config directory and rename the "Config.
wri.backup" file to "Config.wri".
10 Customised
logo
Only for remote display on WLAN capable digital picture frames: A customer-specific logo can be stored
on the USB flash drive. The logo will be displayed at the upper right of the system image. The position
of the logo is predetermined.
10.1 Requirements to the logo template
The maximum size of the customised logo is
200 x 40 pixels (l x w).
Larger logos are scaled to fit into this image size. This results in a corresponding loss of quality! There-
fore, please use the specified image size. The width-to-height ratio is maintained!
The suffix for each of the images must be "jpg". The name of the logo file is: "logo.jpg".
10.2 Integrating a customised logo
1. Disconnect the IFA router and digital picture frame from the mains.
2. Remove the USB flash drive from the IFA router and plug it into the USB port of a PC.
3. Copy the logo file "logo.jpg" into the directory "share -> Logo".
4. Remove the USB flash drive from the USB port of your PC and plug it into the IFA router.
5. Connect the IFA router to the mains. When the router is ready for operation the logo is displayed at
the upper right of the system image.
6. Connect the digital picture frame to the mains and make any necessary setting changes.
Notice
Do not format the USB flash drive!
