24
Software Configuration
Q-Logic™ 3 Setup: Proportional Output
WARNING
Manually disengage both drive motors before utilizing the
Setup
Wizard
,
Diagnostics
, and/or
Config
. If the motors are not
disengaged, the chair could move during setup.
WARNING
The chair
must
be completely powered off before operation.
9.
Use the
Left
navigation button to go back into the
Enhanced Display
folder.
10. Use the
Up
and
Down
buttons to scroll to the
Proportional Input
folder and use the
Right
button to select it.
11. In the
Proportional Input
folder, use the
Up
and
Down
buttons to navigate to and select the
Proportional Calibrations
option. Select
OK
. The programmer will read,
"Roll around joystick in
two full circles".
12. On your i-Drive mobile app, go to
Config Mode
, then select
Calibrate Chair.
13. Note the warning that appears and select
OK
. The app will now automatically begin
calibration. Once calibration is complete, the app will automatically return to
Config Mode.
14. Using the Q-Logic programmer, select
OK
and verify that calibration was successful.
15. Exit the programming. Unplug the programmer and cycle power.
16. Check your configuration on the app's
Diagnostics
tab. If everything is functioning correctly,
your i-Drive is ready to use.
1.
Power off the chair using the power button on the joystick or display.
2.
Ensure all display cords are properly connected to the chair.
3.
Connect the i-Drive 9-pin connection into the port on the bottom of the Enhanced Display.
4.
With the chair powered off, open the i-Drive mobile app on a Bluetooth-enabled device and
log in using the email and password provided to you. Power the chair on and connect to the
application.
5.
Plug in the Q-Logic Programmer (HHP) to the back of the Q-Logic display.
6.
On the Programmer, navigate to
Program Adjustments
option and use the
Right
button to
select it.
7.
In the
Program Adjustment
menu, navigate to the
Enhanced Display
option and select it.
8.
In the
Enhanced Display
folder, use the
Up
and
Down
buttons to navigate to the
Input
Configuration
option. Set this to:
a)
3-Direction Proportional Head
for any configuration that does not have a reverse
direction assigned, such as a 3-switch head array or linked left/right driving.
b)
Proportional
for any configuration that includes an assigned reverse direction, such as a
5-switch head array, a Sip ‘n’ Puff combo, or a PMPJ-1.
