4
Installation Instructions
9.0
Step 3 9.3
Mounting Hardware Alignment
NOTICE
For ease of installation & removal, make sure both the clamp and latch assembly are
aligned properly.
Clamp Alignment:
Align clamp assembly parallel to the seat frame
by rotating as needed.
Wheelchair seat
base frame
Parallel
Parallel
Parallel
Centered
Centered
Parallel
Wheelchair
Back Post
Latch Assembly Alignment:
Make sure the receiving hooks of the latch
assembly are centered within the valley of the
posts and parallel to the back post of the
wheelchair.
Latch centering may require width adjustment. See “Width Adjustment” (pg. 6) for instruc-
tions.
You will need to test initial mounting hardware placement by inserting and removing the
backrest several times.
If the quick release hardware sticks or is not smooth, you may need to re-align the
mounting hardware receiving points on the back posts. To achieve proper alignment,
slightly move the mounting hardware in or out and/or up or down. Make adjustments until
the backrest smoothly inserts and removes from the top and bottom receiving posts.
After final adjustment is complete, tighten all screws to the proper torque specification.
This will ensure secure placement and safe operation.