6
Installation Instructions
9.0
Step 5 9.5
Height Adjustment CF Series:
With a 4mm Allen Wrench, loosen left and right
clamp assembly screws and slide clamp up or down.
Height Adjustment AL Series:
Repeat steps above, or loosen 10mm hex nuts and
slide back up or down to achieve desired height.
Width Adjustment
1.
Remove fabric cover from back support. (Only re-
quired on CF Series Backs)
2.
On each side of the hardware, loosen the top and
bottom screws (as shown ), using a 10mm wrench.
3.
Adjust hardware inward or outward to achieve required chair width.
4.
After final adjustments are complete, tighten all screws to the proper torque specification.
Angle Adjustment
1.
On each side of the hardware, loosen the top and bottom screws with a
4mm Allen Wrench.
2.
Adjust back support to achieve desired user angle.
3.
After final adjustments are complete, tighten all screws to the proper
torque specification.
Depth Adjustment
1.
On each side of the hardware, loosen the top and bottom screws with a
4mm Allen Wrench.
2.
Slide back support forward or aft to achieve desired users depth.
3.
After final adjustments are complete, tighten all screws to the proper
torque specification.
NOTICE
On CF series, you will need to use a 4mm Allen Wrench on inside screws.
NOTICE
+/-1” width adjustment.
CAUTION
ADI backs may not fit every chair; please consult
your clinician or supplier providing your equipment.