3
Installation Instructions
9.0
Step 2 9.2
Fasten Quick Release Clamp Assembly to Wheelchair Back Post
4mm Allen Wrench Required
1.
Remove existing wheelchair back according to the original manufacturer’s instructions.
2.
Visually determine the desired height of your new ADI back support. Mark on each back post
the needed location to attach clamp assemblies.
3.
Slide clamp assembly over top of back post (receiving post facing inward) and slightly tighten
each m5 screw with a 4mm Allen Wrench at the needed height location on wheelchair back
post. Align clamp assembly parallel to the wheelchair seat base.
NOTICE
The mounting hardware should be installed at equal heights on the left and right sides,
and parallel to the seat frame.
NOTICE
Tighten clamp screws, but allow for movement so you can adjust the receiving posts.
Place one finger on each m5
nut (shown below) during fas-
tener engagement.
Fits 3/4” through 1”
Tubing
No spacer required
Use
4mm
Allen Wrench
