Page 1-2: StrikForce Users
Page 3: Non-StrikForce Users
1
Kill Switch Directions
StrikForce Users
3 Plug Options with Keyfob
"Charger Port" Plug........
Page 1
Wireless Power Module Plug........
Page 2
Wired to joystick Power Module Plug........
Page 2
("Charger Port" Plug)
(In chair)
Push the plug into the Charger Port just like you would if you were going to charge the chair.
(After rotation)
If the user is in trouble:
1.
Push the button on the keyfob.
** This will stop the chair from moving. The chair will then
act
as if it just got plugged into the charger
2.
To be able to resume driving, you must Power off the chair first.
3.
When you are comfortable and ready/able to drive properly again, turn the power
back on again.
**Make sure the joystick is centered before the chair is turned on again.
**If the chair will not reset (just showing the battery bars and acting like it's charging), push the
button on the keyfob again to reset the joystick and go to step 2.
**This WILL NOT reset joystick settings
and the chair WILL NOT resume driving after the second button push.
If the plug does not fit in the receiver due to
mounts or tubing:
1.
You are able to rotate the plugs. Once you open the
housing by loosening the two screws with a small
Allen Wrench.
2.
Once inside, you are able to turn the plugs by 45
o
increments. You may have to move the plugs up and
down to get it to move and fit properly.
***DO
NOT TURN it passed 90
o
(two turns) in both
directions.
3.
If you notice the wires are tight in the housing, twist
the black mechanism right above the housing until
the wires are no longer tight.
