STC Smartscan NG2, Manual

Page: 67 / 133

EUD-2018086-00 Rev.3, SmartScanNG² User's Guide for Wayside Enclosure Components, 14 May 2021
67
8.8 Identifying the Installation Tools
Besides the tools needed to install signal cases, underground cables, and power services, you
need these to install your SmartScanNG² system.

Laptop computer

Track drill with 3/8-inch bit

1/2-inch drive socket with 9/16-inch deep well socket

3/4-inch drive socket with 1-7/16-inch socket

9/16-inch torque wrench

Medium-size adjustable box wrench

Carpenters level

1/2-inch nutdriver

11/32-inch nutdriver

#2 Phillips head screwdriver

Small slotted screwdriver (aka flathead screwdriver)

50-foot (15-meter) or longer tape measure

Multimeter, reading at least 110 to 120 VAC, 0 to 50 VDC, and 0 to 1 megohm
In the box containing the bearing scanners are these tools.

Short-handle 1-1/2-inch open-end wrench, which is used to install the scanner mounts
and the deflectors

T-handle 3/16-inch hex-wrench, which is used to install the flex-conduit-adapter plates
on the scanner mounts

T-handle 1/4-inch hex-wrench, which is used to install the scanners on the scanner
mounts

Two combination 9/16-inch open-end box wrenches, which are used to install the
transducers and align the scanners
When you finish using the supplied tools, store them in the wayside enclosure, if possible.
They are also used to maintain the system.