ENGLISH
15
15
4.
Spindle motor.
5.
Switch on / off.
6.
Locking key switch on / off.
7.
Speed adjustment.
Noise/Vibration Information
Measured values determined according to EN 62841-1
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m2/s
WARNING
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given in EN 62841-1 and may
be used to compare one tool with another.
The vibration emission level will vary because of the ways in which
a power tool can be used and may increase above the level given
in this information sheet.
This could lead to a significant underestimate of exposure when
the tool is used regularly in such a way.
Note:
To be accurate, an estimation of the level of exposure
to vibration experienced during a given period of work should
also take into account the times when the tool is switched off
and when it is running but not actually doing the job. This may
significantly reduce the exposure level over the total working
period.
Assembly
Before any work on the machine itself, pull the mains
plug.
Changing the Tool
Stirrer Paddle with Male Thread, Size M14/M18 (Mod DM1600)
EScrew the stirrer paddle 3 onto the drive spindle 4
Hold the drive spindle 4 in place with an open-end
spanner (size 22 mm ) and the stirrer paddle 3
with a second open-end spanner (size 22 mm).
The stirrer paddle is disassembled in reverse order.
Operation
Operation and use
Improper use can cause damage to the tool. Please observe
the following instructions:
- only use tools up to the prescribed diameter.
- only use the tool at loads which do not reduce the speed
severely or bring the tool to a standstill.
- Check whether the data on the type plate comply with the
actual voltage of mains supply. Tools intented for 230 V.
may also be connect to 220 V. / 240 V.
Fitting the mixing tool
Screw the tools with the end piece M14 x 2 as far as possible
into the tool holding fixture and tighten with the spanner (22
mm.) included in the accessories.
Switching on and off
To switch the tool on, press the switch
5
and hold it down.
To switch the tool off, release the switch
5
.
Model DM L20: To start push trigger 8 forward and press
switch 5. To switch off, release switch 5.
Continuous operation
To switch on continuous operation:
press the switch
5
up
to the stop and at the same time press the locking button
6
.
The switch 5 locks, and continuous operation is activated.
To switch off continuous operation:
press the switch
5
again and then let go. The lock on the switch
6
is released,
and continuous operation is deactivated.
Removing tools (mixer)
Fit the flat spanner (22 mm) onto the hexagon of the tool end
piece (mixer) and turn to the left to unscrew the tool from the
spindle.
Motor electronics / Operating motor electronics
Starting current limiting
The electronically controlled soft start ensures that the
machine starts smoothly. This also prevents spray from thin
liquids when the tool is switched on.
The lower starting current means thar a 16 A fuse is large
enough for the machine.
Preselection of rotation
With the rotational adjustments can be preselected power
progressively rotation. The rotation required depends on the
material to be it is advisable to pre- mix and make acheck
through a practical control.
Gear selector
In models with two mechanical speed 1 speed , high torque
for thick mixtures and speed 2 , medium pair , for lighter
blends that enable faster work is used. With the machine off
using the selector 1 to change the fly.
It is possible to change fear when the machine is running.
However , this should not be done wen the machine is at
full load.
