11
• Before replacing the Flame Spreader and Burner Cap, ensure that the
Injector is not blocked.
• A full operational test and a test for possible leaks must be carried out after
a gas conversion.
• After completing conversion, the quailified gas engineer will need to mark
“V” on the right gas category to match with the setting on the rating plate.
Remove the previous setting mark.
Positioning
Clearances required when fitting the hob with a cooker hood above:
This appliance is to be built into a kitchen unit or 600mm worktop,providing
the following minium distances are allowed
• The edges of the hob must be a minimum distance of 60mm from a side
or rear wall.
• 700mm between the highest point of the hob surface (including the
burners) and the underside of any horizontal surface directly above it.
• 400mm between the hob surfaces, providing that the underside of the
horizontal surface is in line with the outer edge of the hob. If the underside
of the horizontal surface is lower than 400 mm, then it must be at least
50mm away from the outer edges of the hob.