10
Important: For butane/propane gas, the adjusting screw must be tightly
screwed in.
• Refit the control knobs to each Gas Tap.
• Test the flame by quickly turning the Control Knob from maximum
to minimum, if the flame goes out then you will need to make further
adjustments to the gas flow.
• Repeat the process again until the gas flow is correct.
WARNING: Do not dismantle the Gas Tap Shaft: In the event of a
malfunction, change the whole tap.
Injector
Control handle
Sealing ring
Tap
Change the Injector of the Burners
• Remove the pan support, burner lid and
flame spreader.
• Unscrew the injector using a 7mm box
spanner and replace with new injector correct
for the new gas supply. Ensuring that the new
injector is firmly tightened.
• Carefully reassemble all the Burner Cap,
Burner Crown and Flame Spreader.
Adjustment of Minimum Level of the Flame
• Ignite the burner and set to MIN Remove
the Control Knob and place a small bladed
screwdriver in the centre of the Gas Tap Shaft.
• Adjust until a steady flame is reached, about
3 – 4mm and does not extinguish when the
Control Knob is turned down to MIN.
• Repeat this procedure for all burners.