76
you want to connect a Self-Guard with other Self-Guards, you need to know the
Bluetooth ID of the Self-Guard that you want to access the data of.
In “TRANSMIT” mode, even if the Self-Guard was cut from the power resources
(battery or the adaptor), it automatically turns on itself, and returns to “TRANSMIT”
mode as the Self-Guard gets provided with the power resources again. This function is
very useful when you set the Self-Guard in a remote place from where you are, and
cannot control over it immediately. All the functions in “TRANSMIT” are the same as in
“1.RECORD”, except that the Self-Guard does not record data in “TRANSMIT” mode.
6. BLUETOOTH (SG-300, SG-310 only)
When using the Bluetooth, you can get faster image transmitting speed by setting the
image compress resolution to 128x128 for the slave Self-Guards. The transmitting
speed goes down as you increase the image compress resolution and set it higher than
128x128. It is recommended to set the image compress resolution to 128x128 when
using the Bluetooth.
Select “BLUETOOTH” using the direction buttons, and press [ENT]. Then the next
screen appears in the LCD as below. To go to the previous menu, press [ESC].
Summary of Contents for Self-Guard SG-100
Page 24: ...24 GETTING READY Self Guard...
Page 83: ...83...
Page 85: ...85...
