-6-
Wiring
For proper installation and full operability, this light requires a 20A ignition switched power
source, connections to the negative terminal of the battery, and 4-6 external switches rated
for a minimum 1A
(user supplied)
.
These lights come with a pre-installed 8-conductor harness. In addition, the cable also
contains a bare drain wire and foil shielding.
BLACK
BARE
White w/Brown - TD Warn (or Pursuit/Flashing White Lights)
Green w/Yellow - TD Left (or Takedowns/Steady Burn White)
Yellow - TD Right (or California Title 13 Lights/Steady Red)
Green w/Red - Pattern Select or Dim
Red - Ignition Sw12VDC
User Supplied Switches
Orange w/Red - Level 2 Flashing Warning Lights
Orange w/Green - Level 1 Flashing Warning Lights
+12VDC
+12VDC
+12VDC
+12VDC
+12VDC
+12VDC
+
-
20 AMP
FUSE
Quick Wiring Guide
All wires connected to the positive terminal of the battery should be fused at the
battery for their rated load.
Testing the light before this fuse is properly
installed will void the warranty on the light.
Please Note:
When the red wire is connected to +12VDC the light will draw a
small current (2 mA). Occasionally vehicles may sit for extended
periods of time (i.e. more than a few days), thus we recommend that
the red wire be routed through an ignition switched power source.
Both = Center-Out Pattern
White w/Brown TD Warn Pattern
Green w/Yellow TD Left
Yellow
TD Right
MUST BE CONNECTED
Summary of Contents for Lineum Star Phantom ULB48-TD
Page 16: ... 15 ...
