-11-
Program Mode (Cloning)
If you are installing multiple lights and have a number of
options to set, you may find it easier to set up one light,
then “clone” its settings onto the other lights. To do so,
proceed as follows:
1. Program the first light as described.
2. Connect the second light to the programmed unit using
a special telephone-type cable
(P/N SWH-140 available
from the manufacture upon request)
between the two
communications ports.
3. Flip the Program Mode switches from both lights onto the ON position (DOWN in the
diagram above). Both lights should start flashing all Traffic Director lights.
4. Press the Phase button on the light you would like to reprogram and hold it until the
Traffic Director (or Pursuit) lights go off and the colored lights start flashing. Release the
button and the new programming information will begin uploading to the second unit.
Once it has successfully completed uploading all of the programming, the entire light will
illuminate into a steady burn mode. Repeat programming if not.
5. Flip the Program Mode DIP switches from both lights into the OFF position and remove
the cable connecting the lights. Programming should be completed.
Programming (CONT'D)
ON
CT
S
1
2
3
P
h
a
s
e
H
e
a
d
E
n
a
b
le
Communication
P
ro
g
ra
m
M
o
d
e
H
ig
h
-L
o
w
/P
a
tt
e
rn
T
ra
ff
ic
D
ir
e
c
to
r/
T
a
k
e
d
o
w
n
Resetting to Factory Default Settings
1. Connect the Red wire to power and the Black wire to Ground.
2. Flip the Program Mode switch ON position (DOWN in the diagram above). All Traffic
Director (or Pursuit) lights should start flashing.
3. Press and hold the Head Enable button until the Traffic Director (or Pursuit) lights go off
and all of the heads light up sequentially from left to right.
4. Once all of the heads are illuminated, release the Head Enable button and the light will
be restored to the factory default settings.
5. Flip the Program Mode DIP switch into the OFF position.
Summary of Contents for Lineum Star Phantom ULB48-TD
Page 16: ... 15 ...
