-12-
Operating Instructions
Functions Switched Through Wires
Main control of this light is done though the wires in the harness. They should be connected
to +12VDC through several switches
(user supplied)
as described in the
Wiring
section.
TD Warn
(White w/Brown)
Usually activated when a vehicle has been pulled over. The amber lights will flash in the
WARN pattern you have them programmed for.
Level 1 Flashing Mode
(Orange w/Green)
This is usually intended as a slower, less urgent mode typically used when parked.
Level 2 Flashing Mode
(Orange w/Red)
This mode is intended for high-urgency situations, such as a high speed chase, requiring
significant warning power. It is usually a faster pattern than Level 1.
The Level 2 pattern will override Level 1 lights.
TD Left
(Green w/Yellow)
Ap12VDC to this wire will produce a pattern directing traffic left.
TD Right
(Yellow)
Ap12VDC to this wire will produce a pattern directing traffic right.
Center-Out
(Green w/Yellow)
and (Yellow)
Ap12VDC to BOTH of these wires will produce the Center-Out Pattern.
Dim Option
DIM
(Green w/Red)
If the High-Low/Pattern Option is set for High-Low (see page 7), then ap12VDC
will dim the light (typically used in nighttime applications).
Activation of Multiple Functions
Depending upon programming, the light will have different outputs when multiple functions
(i.e. switches) are activated at the same time. Please review
Pattern Cycling of
Simultaneous Functions
on page 10 to determine how your light is programmed.
NOTE:
RED MUST BE CONNECTED TO POWER
BLACK MUST BE CONNECTED TO GROUND
Summary of Contents for Lineum Star Phantom ULB48-TD
Page 16: ... 15 ...
