Theta Controller
Programming
25
Communication Screens
Options Screen
82
SET_TIME
127
ABORT_JOB
9999
KEEP_ALIVE
Barcode / Printer - The port performs both
functions.
Barcode – The port reads input from a
barcode scanner and places it into the PART
ID buffer. Data in the PART ID buffer is
added to the fastening cycle data when stored
and transmitted via a network protocol or
printed.
Printer – A pre-defined data string is sent to
the port after each tightening cycle that
exceeds the Threshold Torque. See section
4.1.3 Theta Controller Serial Connector for
string definitions.
Toyota – Connects this port to the Toyota PI
box.
Press EXIT and return to the Run screen.
2.8.3
Setup Menu: 3. Other
Other Screens
Options Screen
This area sets the parameters for all other Theta features, including: system level, users,
passwords, I/O and tool functions. Each category is represented by its own tab. Use the
left/right arrows to select the tabs/category for modification.
Users must have ADMINISTRATOR or SETUP access level to modify values in this area.
Select Other by pressing the SETUP
interactive menu button on the Run screen.
Press 3 or highlight selection and press
Toggle button.
2.8.3.1
General Tab
Name – This name distinguishes this
controller from other Theta controllers on the
same plant floor.
Keypad Mode – During normal operation the keypad on the face of the controller can be used
to select Jobs (Job Select) or Tasks (Task Select). It can also write a PART ID for storing with
fastening cycle data or these functions can be disabled.
