14
If you are unable to correct a fault yourself, please contact our technical support directly. Please note
that improperly conducted repairs will void your rights under warranty and may cause you additional
expenses.
Contact service partner.
Fault/malfunction
Cause
Remedy
Motor will not start.
Is the tank empty?
Filling with fuel
Is ignition switch set to "STOP"? Set ignition switch to "ON".
Ignition cable plug loose?
the spark plug.
Ignition cable plug dirty?
Clean the plug.
Is there excess fuel inside the
combustion chamber?
Push choke lever to
,
start the motor a few times.
If the motor will not
start: remove the spark
plug and dry the electrode.
Spark plug dirty?
Clean the spark plug
Is the distance between the
electrodes of the spark plug
too large?
Set the gap to 0.6 to
0.7 mm.
Wrong fuel or mixture?
with the correct mixture.
Spark plug defective?
Cleaning/replacing
the spark plug
Cutting equipment runs while
motor is idling.
Wrong setting for idling?
Contact service partner.
Cutting equipment continues
to run after throttle has been
released.
Clutch set incorrectly?
Motor will not reach its maximum
speed.
Spark plug dirty?
Cleaning/replacing the spark
plug
Is the electrode separation of
the spark plug too large?
Set the gap to 0.6 to
0.7 mm.
Wrong fuel?
with the correct fuel.
G
B
