Stanley FATMAX FMHT77652, User Manual

Page: 8 / 166

GB
8
• The colored LEDs on the front of the Detector (Figure
A 6
) indicate whether the Detector is above the
laser beam ( Red ), aligned with the laser beam ( Green ), or below the laser beam ( Blue).
• The Laser Detection icon on the LCD screen (Figure
E 5
or
E 6
) will show how close the
Detector's Reference Line is to the laser beam. The greater the number of bars in the icon, the farther
away the Reference Line is from the laser beam. If the laser beam is found within the Detector's range, the
LCD screen will also display the Digital Height Reading (Figure
E 8
) between the Reference Line and
the laser beam. If the laser beam is detected outside the Detector's range, OUT will appear instead of the
Digital Height Reading.
• The audible beeps, unless sound is muted.
Lining up the Detector's Reference Line with a Laser Beam
Red
Green
Blue
Laser Detection Icons
(Indicate whether you need to move the Detector UP or DOWN)
Red
Fast Beep
OUT
Move down
> 50 mm
Move down
30 to 50 mm
Move down
20 to 29 mm
Move down
10 to 19 mm
Move down
5 to 9 mm
Move down
1 to 4 mm
Green
Detector's Reference Line is lined up with the laser beam
Steady Beep
Blue
Slow Beep
OUT
Move up
> 50 mm
Move up
30 to 50 mm
Move up
20 to 29 mm
Move up
10 to 19 mm
Move up
5 to 9 mm
Move up
1 to 4 mm
3.
When the Detector's Reference Line (Figure
A
1
) is aligned with the laser beam , mark that position.
NOTE: If the top of the Detector is used as a marking location, reference the back of the Detector for the
measurement compensation value (Figure
A 7
).