Stanley FATMAX FMHT77652, User Manual

Page: 6 / 166

GB
6
Installing AA Batteries
WARNING:
Pay close attention to the battery holder’s (+)
and (-) markings for proper battery insertion.
Batteries must be of same type and capacity. Do
not use a combination of batteries with different
capacities remaining.
1.
On the back of the Detector, lift up the battery
compartment door (Figure
B 1
).
2.
Insert two new, high-quality, name brand AA
batteries, making sure to position the - and +
ends of each battery as noted inside the battery
compartment (Figure
B 2
).
3.
Push the battery compartment cover closed until it
snaps in place (Figure
B
3
).
4.
Press to turn the Detector ON.
5.
Check the battery icon (Figure
E
1
) on the LCD
screen. It should show that the battery is Full.
Battery Charge Level
Full
About 2/3
About 1/3
Batteries need to be replaced.
6.
If you are not ready to use the Detector now, press
and hold for at least 2 seconds to turn the
Detector OFF to conserve the batteries .
Using the Detector
The D
E
WALT Digital Laser Detector can be used with
or without the detector clamp. When used with the
clamp, the detector can be positioned on a grade rod,
leveling pole, stud, or post (Figure
D
).
Attaching the Detector to the Clamp
1.
Use the alignment holes (Figure
A
8
) to guide the
clamp onto the detector (Figure
C 1
).
2.
Turn the attachment knob (Figure
C 2
) clockwise
to secure the Detector on the clamp.
3.
Turn the clamp knob (Figure
D 1
) counterclockwise
to open the jaws on the clamp.
4.
Place the clamp on the rod (Figure
D 2
) so the
detector is positioned at the height needed to work
with the laser.
5.
Turn the clamp knob (Figure
D 1
) clockwise to
secure the clamp on the rod.
Notice that the Detector's Reference Line is lined up
with the top edge of the clamp (Figure
D 3
) . Later
when you align the Reference Line with a laser beam,
you will use the knob (Figure
D 1
) to loosen the clamp
and move the Detector up or down, as needed.
Turning the Detector ON
1.
Press to turn the Detector ON.
2.
Make sure all the icons are displayed momentarily
on the front LCD screen (Figure
A 4
) and the
back LCD screen (Figure
A 5
).
Illuminating the LCD Screen
When the Detector is ON, press to turn ON/OFF
the light on the LCD screen.
NOTE:
If after 60 seconds, a laser beam is not
detected or a button is not pressed on the keypad, the
LCD screen will automatically turn off.
Adjusting the Accuracy Setting
By default Accuracy is set at HIGH. Use a lower
accuracy settings when:
•
A high accuracy setting is not needed.
• A stable reference level cannot be obtained due to
vibrations.
• Heat haze interferes with the laser beam.