15
REMOTE CONTROL OPERATION
NOTE:
If not using the mains adapter, it is recommended that the batteries are replaced in the gas
control box at the beginning of the heating season (see Battery Replacement Section). The
control box will provide frequent beeps for 3 seconds when the batteries are low. A low battery
indicator will be shown on the remote control display when the batteries are low on the remote.
MANUAL MODE
To allow for remote control operation, make sure
that the Manual Knob on the gas valve is in the ON
(Full counterclockwise position) and the ON/OFF
switch is in the I (ON) position - refer to Fig 18.
Press & hold the Power Button two short beeps are
heard and a blinking series of lines appears on the
remote display (see Fig 19). This indicates that the
start sequence has begun during which the ignitor
will spark until the pilot flame lights. When the pilot
flame has lit and stabilised, the main burner will
ignite & light.
NOTE:
If the pilot light does not stay lit
after several attempts, turn the
main valve knob to OFF and
contact your local service
engineer.
When the main burner flame has been established,
the flame height can be adjusted by (refer to Fig 20):
*
Increase - Press & Hold the Up Arrow Button.
*
Decrease - Press & Hold the Down Arrow
Button
Fig.19
Fig.18
POWER BUTTON
COUNTDOWN
TIMER
TEMPERATURE
BUTTON
UP ARROW
DOWN ARROW
PROGRAM
BUTTON
REAR BURNER BUTTON
ECO BUTTON
ON/OFF SWITCH
MANUAL KNOB
Summary of Contents for Argon F500 OVAL
Page 23: ...WIRING DIAGRAM 23 ...
