Standen ZENO 21, Manual

Page: 25 / 65

Setting Up The Control System
Turn the control system ON. When fully powered up, the ‘home’ screen will display
(see fig 35).
To ensure the calculations for seed spacing and seed coverage are correct, the
following information must be set.
1.
Press the icon once.
2.
Imperial or Metric Units
Select either Imperial or Metric (see fig 37).
3.
Number Of Active Rows
Using the yellow arrows, scroll until the ‘active rows’ screen is displayed (see
fig 40). Turn rows ON / OFF using the + and – icons. If only 1 row is selected,
the RH row will be active. On a 3-row planter, selecting 2 rows will turn the
centre row OFF.
4.
Centre Row Reduction (3-row only)
Using the yellow arrows, scroll until the ‘centre row reduction’ screen is
displayed (see fig 41). Using the + and – icons select the percentage
reduction. Alternatively, press the digits to display a keypad.
5.
Press the icon for 3 seconds.
6.
Wheel Circumference
The ‘wheel circumference’ screen is displayed (see fig 44). This setting is
factory set. If the wheels are changed this figure will need to be reset. With the
planter wheels on the ground, mark the sidewall of the tyre at the bottom and
continue the mark onto the ground. Drive forward for one revolution of the
wheel and mark the ground again. Measure the distance between the two
marks. Record circumference using the + and – icons.
7.
Wheel Setting
Using the yellow arrows, scroll until the ‘wheelings’ screen is displayed (see fig
45). Record the wheel setting using the + and – icons. Alternatively, press the
digits to display a keypad.
8. Row Configuration
Using the yellow arrows, scroll until the ‘row configuration’ screen is displayed
(see fig 50). Using the + and – icons, select the number of openers fitted to
your planter.
9.
Seed Spacing
Press the icon . The ‘seed spacing’ screen will display (see fig 36). Select
the desired seed spacing using the + and – icons. The number of sets per
hectare / acre updates automatically. Alternatively, press the digits to display a
keypad.
10.
Press to return to the ‘home’ screen.
OPERATION 1.20