Standard Horizon PC-P430, Manual

Page: 27 / 36

15
Replacing the Cutting Stick
Attaching the Cutting Stick
Hold the cutting stick with side you
want to use facing up.
- One side of a cutting stick can provide two
working lines. One cutting stick can provide eight
working lines on the four sides.
- If a side which was already used is uneven,
smooth out the uneven surface.
- If the surface is stained, wipe the surface.
Loosen the locking knob using the
supplied Allen wrench (4mm) and
open the door.
Insert the cutting stick in the groove
through the door.
1
Insert the cutting stick in the groove through
the door.
2
When the cutting stick has been inserted
halfway into the groove, fit the cutout of the
cutting stick replacement tool over the cutting
stick.
3
Turn the cutting stick replacement tool
counterclockwise to hold the cutting stick.
4
Move the cutting stick up against the left stopper
using the cutting stick replacement tool.
5
Release the cutting stick so the right end of the
cutting stick is touching the right stopper.
6
Check that the new face of the cutting stick is
level with the top of the table. If it is not, remove
the cutting stick again and smooth out the
uneven surface, or use a new cutting stick.
14044
20602A1
Uneven
14044
20701D1
Locking
Knob
14044
20602C1
Cutting Stick
14044
20602B1
Table
Left
Stopper
Cutting Stick
Replacement Tool
Right
Stopper