Standard Horizon PC-P430, Manual

Page: 17 / 36

5
This section explains how to do some basic operations.
Press both Cutting buttons at the
same time and keep pressing until the
cutting action is finished.
Open the safety cover and remove the
cut sheets.
- Open the safety cover, and pull the sheet pusher
lever toward the operator position until the lever
stops moving.
The cut sheets will move forward by 25 mm (1”).
- Remove the trim.
- Remove the cut sheets.
After the cutting operation is finished,
Close the safety cover.
Turn off the key switch.
- Turn the key switch to the left and remove the
key.
Cutting Operation
14044
10201A1
Cutting Buttons
Press both Cutting buttons until the LED
goes out and the LED lights.
If one of the Cutting buttons is released while
the machine is cutting, the cutting action will
stop and the knife will automatically return to
the starting position.
14044
10201B1
Sheet Pusher Lever
14044
10201C1
If the cutting length is 70 mm (2.8”) or shorter,
the sheets will move forward by shorter
distance.
- Use a brush to remove any trim
on the edge of the knife. Keep
your hands and fingers away from
the edge of the knife.
- Do not place your hands or
fingers under the knife or the
clamp.
WARNINGS
14044
10201D1
- Only the authorized person should have
access to the key.