Stairmaster Air Fit, Owner'S Manual

Page: 12 / 32

Assembly & Setup
Use the following procedures to unpack and assemble your Air Fit™
.
UNPACKING AND PARTS LIST
Position the shipping carton so the “Heavy End” logo is located at the bottom. Open the top of the carton and fold back all four flaps. Carefully tilt the box forward so
that the box may be lifted to expose the bike. Remove all parts from the shipping carton and foam inserts, and verify that the following parts are included in your
shipment:
NOTE: All tools required to assemble the bike are included within the packaging, except for a Rubber Mallet, which is recommended when assembling the pedals
onto the bike.
Air Fit™ Parts List
Description Qty. Description Qty.
Main Frame Assembly 1 M8x15mm Button Head Bolt 14
Console Mast 1 M8x16 O.D. Flat Washer 14
Console 1 M8x20mm Socket Head Cap Screw 2
Left and Right Arms 2 M8x25mm O.D. Flat washer 2
Left and Right Foot Stand 2 M24x1.5 Hex Jam Nut 2
Left and Right Foot Pedals 2 M8x20mm Button Head Bolt 4
Seat Post 1 M8x1.24x14mm Specialty Hex Screw
M4x10mm Socket Head Cap Screw
M4x10mm Phillips Pan Head Form Screw 2
2
2
Take time now to enter your Air Fit™
serial number in the space below (serial number is located on underside the bottom rear cross member).
If parts are missing, or if you have any operational questions, please call StairMaster’s Service department at (888) 678-2476, option 2.
Have your serial number ready.
Serial No._____________________________________________
NOTE:
If you are missing any of the parts listed above, inspect the packing material and the box for items that may have been overlooked.
If parts are missing, or if you have any product questions, please call StairMaster’s Service Department at (888) 678-2476, option 2. Please have your bike’s serial
number ready.
CAUTION:
Damage to the bike during assembly is not covered as part of the limited StairMaster warranty. Take care not to drop or lean the bike on the handle bar
pop-pin. Carefully stand the bike up in the normal upright position on a stable surface so it will not tip over during assembly.
Owner’s Manual
12