19. Insert the assembled seat post (Fig. 20) into the frame by pulling on
the pull pin located on the upright column of the frame and sliding
the post downward along with the plastic sleeve verifying to lock the
post into one of the available positions.
Fig. 19
20. Mate the edge of the plastic sleeve flush with the edge of the
upright tube (Fig. 21) and install the corresponding hardware to lock
the plastic sleeve in place.
Hardware
QTY
M4 x 10mm Phillips Pan Head Thread Form Screw
2
Fig. 20
21. Review all areas of the machine to verify no hardware was left loose
and adjust the leveling feet under each foot (Fig. 22) incase the base
is not resting on flat even ground.
Owner’s Manual
19
Summary of Contents for Air Fit
Page 1: ...Air Fit 620 8245 Owner s Manual Owner s Manual 1...
Page 29: ...Owner s Manual 29...
Page 30: ...Owner s Manual 30...
Page 31: ...Owner s Manual 31...
