5
Installing/Removing Dash
1.
Install mount to proper specification (see
).
2.
Orient device in either portrait or landscape
position and line up with mount.
3.
Make sure lip of the mount is behind the aluminum
mounting rail.
4.
Slide Dash downward until the thumb tab audibly
clicks tab into place.
5.
Check to make sure the thumb tab is properly
seated in the mounting slot.
6.
To remove, pull back on thumb tab and pull up on
dash. The Dash should come out easily, if you are
forcing it, pull further back towards the bike with
the thumb tab.
To install the included safety lanyard (recommended):
1.
With the Dash removed from the mount, insert the
loop end of the lanyard into the hole on the
unused mounting location on the Dash.
2.
Pull the lanyard cord end through the loop.
3.
Slip the elastic side of the lanyard over the thumb
tab and mount arm.
4.
Make sure the lanyard is completely clear of the
thumb tab.
5.
Install the Dash onto mount (
Installing/Removing
Dash
).
Initial Setup
When powering on the Dash for the first time, you will
be prompted with a few questions to set up the Dash.
These settings can always be changed from the
menu.
Power On/Off
To power ON the Dash
: Press .
To power OFF the Dash
: Press and hold for
3s.
