9
Stabila LD 500
Measuring
D
GB
SLO
F
I
E
P
NL
N
FIN
DK
TR
CZ
PL
S
HR
H
SK
LV
LT
KOR
RUS
CHN
EST
GR
RO
Press this button to take the next measurement from the front edge
. A special beep sounds whenever the reference setting is changed.
After a measurement the reference returns automatically to the default
setting (rear reference). See figure {
H
}.
Press this button for
longer
the front reference is set permanently.
Press this button, the rear reference is set again.
Measuring
Single distance measurement
Press to activate the laser. Press again to trigger the distance measu-
rement.
The result is displayed immediately.
Minimum/maximum measurement
This function allows the user to measure the minimum or maximum
distance from a fixed measuring point. It can also be used as determine
spacings. See figure {
I
}.
It is commonly used to measure room diagonals (maximum values) or hori-
zontal distances (minimum values).
Press and hold down this button until you hear a beep. Then slowly
sweep the laser back and forth and up and down over the desired target
point - (e.g. into the corner of a room).
Press to stop continuous measurement. The values for maximum and
minimum distances are shown in the display as well as the last measured
value in the summary line.
Functions
Overview of the program icons
Measuring program
Icon Measurement
1 - 2 - 3
Detail display
1 - 2 - 3
Simple distance measure-
ment
Area measurement
Volume measurement
Trapezoid measurement
1 (using three distances)
Trapezoid measurement
2 (using two distances and
one angle)
Pythagorean calculation 1
Pythagorean calculation 2
Pythagorean calculation 3
Inclination measurement
Direct horizontal distance
Triangular area measure-
ment
Staking out function
