The mounting, disassembling or possible other interventions on the transmission
shaft must be carried out with the engine switched off and with the starter key removed from the
tractor’s control panel.
13
DEFINITION OF THE LENGTH
MOUNTING OF CARDAN TRANSMISSION SHAFT
15° MAX
00081
The cardan transmission shaft must
work with the 2 COAXIAL drive outlets
(PTO) or, should this not be possible,
with the PARALLEL axles. In this case
the angle of the joint MUST NOT
EXCEED 15°.
D
L = D - 40 ÷ 50mm
00082
00083
USE TRANSMISSION SHAFTS WITH CE CERTIFICATION. OBSERVE THE REGULATIONS
CONTAINED IN THE USE AND MAINTENANCE BOOK-LET PROVIDED BY THE SHAFT MANU-
FACTURER.
Set the 2 drive outlets (PTO) perfectly on the same axis and measure the distance “D” between theirgrooves.
Length “L” of the cardan transmission shaft (refer to the picture) to be deployed, measuredbetween the 2 stopping
pawls and with joint closed, must be 40÷50 mm lesser than distance “D”.
Using the cardan shaft too much long-
cause a push on the two PTO, that itcan
cause huge mechanical damages both to
the tractor and to the sprayer.
Using the cardan shaft with too short in
length may cause the serious collision
to the sprayer and to the tractor, and
dangerous for the persons.
ST101-GEO-i 400 / 600 LITER
- Tractor Mounted
.
.
