Eclipse Manual
61
10.
My Stove isn’t burning and the #5 LED light is on Solid (not blinking).
When the
stove is in “Idle Mode” (Not Burning) the control board monitors the Rotation Sensor Switch
(see Figure 22, 23, 49 and 50). In “Idle Mode” the switch should be resting in the notch of the
disc. The #5 LED light being on solid usually means that the Drum in the pot is jammed and out
of position.
The Drum rotating continuously will indicate that the Rotation Sensor switch is not functioning
correctly or there is a wiring problem.
8.
I turned the Stove on with the On/Off switch and nothing happens.
First check to see
if the Stove is plugged in and the receptacle has power to it.
Solution:
Check the fuse on the back of the control board. Replace with a 125 Volt, 5 Amp
fuse.
Is the stove connected to a Thermostat and running is SmartStat Mode? If so, is the Thermostat
calling for heat? Turn the Thermostat up to see if the stove on.
9.
Why is my glass dirty?
Normal operation of your St. Croix Corn/Pellet Stove will
produce a white build-up on the glass that wipes off with a dry paper towel. However extended
burning on the low setting only will produce a tan color. These types of build-up on the glass are
normal. A heavy shiny black build-up on the glass could indicate a problem (too much
combustion air).
Solution:
Adjust the combustion air setting to the proper setting, using the damper or the
Draft settings on the Board, or a combination of both. It also could be an
indication that the Stove is getting plugged and needs a good cleaning. Refer to
the section in the manual that covers the Daily, Periodic and Yearly Maintenance
of the Stove.
Figure 49
Figure 50
