8
Lights
The lights on the profiler are located at the front and rear of the electronics housing. To turn on the
lights, the profiler must be powered on or connected to the charger and the switch for the lights must
be on.
Battery Meter
The battery meter not only illustrates the amount of power left in the battery, but it also indicates
that the profiler is turned on.
Charging
To charge the profiler, connect the color coded charging terminals to the corresponding terminal color
on the back of the profiler
, or if equipped, simply mate the charging plug to it’s receptacle
. The LED
on the charger will turn red when there is a load on the circuit due to charging. The LED will become
green when charging is complete. In some cases the charger may need to be plugged into to 120v AC
before connecting to the profiler.
Adjusting the Right Wheel
The right wheel is adjusted by loosening the set screw at the top of the dovetail assembly. It is
important to not over-tighten the set screw because it may damage the nylon insert. The position of
the right wheel is crucial to the profiler’s stability. For optimum perfo
rmance position the center of
the dovetail 5 inches from the rear of the electronics housing.
Tires and Pressure
Prior to collection inspect the tires to make sure they are aligned with each other. Most units are
equipped with foam tires. For pneumatic tires, the ideal tire pressure is listed on the side. For the 4-
ply tires the maximum pressure is 60 pound per square inch (psi).