27
Lever Blade Installation
L e v e r B l a d e I n s t a l l a t i o n
Install the lever blade.
Line up the pivot holes of the lever blade with the pivot holes in the
lever body.
Make sure your lever return spring is seated properly in the lever. The
outboard end of the spring must press against the lever blade, while
the inboard end of the springs must press against the lever body. If the
return spring is not seated properly, you will not be able to adjust the
reach of the lever blade.
Apply a small amount of Loctite Threadlocker Blue 242 onto each pivot
bolt.
Use a T10 TORX wrench to thread each pivot bolt into the bearings on
each side of the lever body.
1
2
Loctite Threadlocker Blue 242
15 N•m (133 in-lb)
22 mm
3
T10 TORX wrench
15 N•m (133 in-lb)
22 mm
